TESTING DICOM CONNECTIVITY

You can use the dcmnet applications to help you test DICOM
connectivity.  In the following steps it is assumed that you
wish to exchange DICOM messages between a machine called host1
and another machine called host2.  The prompt 'host1> ' in
the examples below means that a command should be executed
on the machine host1.

Step 1:

Make sure that basic TCP/IP connectivity is available.  Use the
ping command which is available on almost all system.
e.g.
	host1> ping host2

	host2> ping host1

If you cannot verify basic TCP/IP connectivity then none
of the following steps will work.

Step 2:

Start up a simple DICOM Storage/Verification Service Class Provider
application.
e.g.
	host1> storescp -v 5678

will start storescp in verbose mode listening on port 5678 for
incoming associations.  storescp will never exit, it will continue
to wait for new associations until terminated.  See storescp.txt for 
more information on the storescp application.

Step 3:

Start up a simple DICOM Verfication Service Class User application.
e.g.
	host2> echoscu -v host1 5678

will start echoscu in verbose mode.  It will attempt to build a
DICOM association with an application running on host1 (attached
to port 5678) and will send a C-ECHO request and await a C-ECHO
response from host1.  See echoscu.txt for more information on the 
echoscu application.

Step 3:

Send a DICOM image to host1.
e.g.
	host2> storescu -v host1 5678 ctimage.dcm

will start the storescu application in verbose mode.  It will
attempt to build a DICOM association with an application running 
on host1 (attached to port 5678) and will send a C-STORE request
containing the contents of the DICOM image ctimage.dcm and await
a C-STORE response from host1.  See storescu.txt for more information
on the storescu application.